So If I turn Iron Volume Off in Gold Mode I should only hear target noise not Iron\Ferrous targets Iron Volume : Activate / de-activate the low ferrous tone. Clegy makes no mention of DISC IAR use in mineralised ground. So in this case, it is better to reduce the level of discrimination. Gold nuggets (buried deep in mineralised ground) generate a similar target signature to a ferrous item. IAR will not reject deeper targets which may come across as ferrous when they are buried in mineralised ground, this is to ensure good targets are not rejected by mistake. What about in Gold mode is Disc IAR doing the same thing? Manual states : It Applies only to targets that produce strong signals typically shallow ferrous items. Is Disc IAR not of any use to reduce Hot rock\Mineraliseation Noise or can a setting of 1 or 2 help to reduce noise ? With coin modes it relates to TID numbers. In the manual it talks about a lot, but explains nothing to do with Gold Mode. I have Quoted the Manual and Clegys settings I mention are from: Clegys XP ORX Settings for Gold in Australia when the going gets a little tough in mineralised areas Link Below: Disc IAR. I could not get the coil anywhere near the ground when keeping the GB numbers the same. One of the biggest problems was the elliptical coil was so bump touchy. What did work is Clegys advice to hit the Pubs. I followed Clegys instructions and tried many different settings but to no avail. The reason I ask all these questions is I just completed a trip using the ORX where hot rocks\Mineralised ground made detecting any targets impossible. Unclear areas in Settings for the ORX in Gold mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |